• Products
  • OT-USB
    (Embedded USB Stack)
  • OT-NET
  • OT-Bluetooth
  • OT-File
• Reference Designs
  • Voice Control System
  • 192KHz Asynchronous USB DAC
• Hardware Modules
  • Voice Control System
  • 192KHz Asynchronous USB DAC
  • I.MX233 SoM - QFP
  • I.MX233 SoM - BGA

Hardware Modules

All our OEM hardware modules are Ready-to-use with integrated firmware.

OEM Modules

• # Voice Control System

  Onchip's speaker independent Voice Control module enables any electronic equipment to be controlled or responded to by human voice. It is a fully integrated hardware and Software solution that can immediately be interfaced to almost any electronic equipment to provide superior voice based interactive user experience.

• # 192KHz Asynchronous USB DAC

  OT-USBAudio is a truly asynchronous 192KHz USB to I2S/SPDIF module capable of streaming 192KHz audio data from high speed USB 2.0 to I2S port asynchronously. The design supports up to 192KHz sampling rate with 24 bit resolution and uses Onchip's proven embedded software stacks to make the module Ready-to-use. No need for any software development or porting.

System on Modules

• # I.MX233 SoM - QFP

  OT0233A SoM from Onchip is a fully integrated ready to use embedded module built on a high quality impedance controlled multi layer PCB. It only requires 5V or 3.7 - 4.2V battery to get up and running at blazing speeds of 454MHz. All the unused pins (except the pins connected to on board DDR RAM and Flash memory) are available through standard 2mm 84-Pin connector in logical groups.

• # I.MX233 SoM - BGA

  OT0233Q SoM from Onchip is a fully integrated ready to use embedded module built on a high quality impedance controlled multi layer PCB. It only requires 5V or 3.7 - 4.2V battery to get up and running at blazing speeds of 454MHz. All the unused pins (except the pins connected to on board DDR RAM and Flash memory) are available through standard 2mm 84-Pin connector in logical groups.